| | Notions Using the following designs Klimt water_01, Klimt water_02, Klimt water_05 and Klimt water_06 1 meter or 1 yard of white fabric 1 meter or 1 yard Floriani Stitch and Shape 1 meter or 1 yard Cut away or tear away 1.5 meters or 1.5 yards contrasting fabric for both piping and lining ¼ meter or ¼ yard of thick wadding Fabric glue 1 meter or 1 yard of grey imitation suede fabric 1 meter or 1 yard of wool batting (or this a bamboo batting, which would be great) Fabric pen 2 handles |
| | |
| | |
  | Stitch all 4 designs on a white cotton fabric hooped with either a cut away stabilizer or a tear away Slide under you hooped white cotton fabric and cut away Floriani Stitch and Shape (You can purchase the Stitch and Shape from United States www.rnkdistributing.com Australia www.florianiembroidery.com.au |
| | |
| | |
| Stitch out Klimt water_01, Klimt water_02, Klimt water_05 and Klimt water_06 |
| | |
| | |
  | Stitch all four panels together. I suggest you stitch Klimt water_01 to Klimt water_02 together Then Klimt water_06 to Klimt water_05 together Stitch both panels you have just stitched together as shown in the photograph |
| | |
| | |
 | Make a piping with a contrasting fabric if you wish. I purchased the fabric a few years ago from a quilting shop in the States, you may still be able to purchase the fabric “Stof Quilters Basics style #4513 designed by www.stof.dk
|
| | |
| | |
| Piping around the edge |
| | |
| | |
 | Close up of piping |
| | |
| | |
| Cut out 2 thick pieces of batting just slightly smaller than Klimt Water panel |
| | |
| | |
 | Glue the double wadding down on the back of the Klimt Water panel |
| | |
| | |
 | Glue the Klimt water panel down on the fabric you wish to make the bag. I used grey imitation suede (The type of glue I use is a glue gun) |
| | |
| | |
 | Measure using your ruler all 4 sides 3cm or 1.3 inches from the edge of the panel |
| | |
| | |
 | Once you have measured 3 cm or 1.3 inches and marked using your fabric pen rule a straight line for cutting with your scissors |
| | |
| | |
| Grey suede cut with scissors. Cut out wool batting the same width and length as the bag front and back and also the side gusset of the bag, this helps to give some stability. I cut strips of grey suede fabric 8cm or 3.2 inches wide for the gusset |
| | |
| | |
| Photo showing the gusset stitched to the front panel of the bag |
| | |
| | |
 | Showing the reverse side of the front panel and gusset with the wool batting Stitch the back panel of the bag to the gusset Add your handles at this stage If you have enough fabric from the binding you used around the Klimt Water panel that is on the front of the bag, then I suggest you use the same fabric for the lining Stitch the lining to your bag |
| | |
| | |
| All finished |
| | |
| | |
| | |
| Instructions for Klimt Composition Foot Stool 
|
| | |
| | Notions 1 meter or 1 yard white cotton fabric 1 meter of stabilizer Klimt Choir of the angels_lge_03 or Klimt Choir of the Angels_sm_01 Foot stool (purchased foot stool from Oz Designs Sydney, but you can purchase these in many stores) Hot glue gun |
| | |
| | |
| White fabric and cut away stabilizer hooped |
| | |
| | |
| Slide Floriani Stitch and Shape under the hoop as shown in the photograph Stitch out 8 Klimt Choir of the Angels_sm_04 |
| | |
| | |
| Using a zigzag stitch to join the borders together as shown in the following photographs |
| | |
 
|
| | |
| | |
| Mark the centre of the foot stool |
| | |
| | |
| Measure the border so the border is evenly from the centre on all sides |
| | |
| | |
| Pin the border down to the foot stool leaving enough room for you to apply your glue gun Put dabs of the hot glue all around the border, just small dabs, just in case you make a mistake and you can easily lift the border and move the border slightly Once you are happy with the position of the border on the foot stool then hot glue the border down properly |
| | |
| | |
| Place either “Klimt Choir of the angels_lge_03” or “Klimt Choir of the angels_sm_01” depending on which size design you wish to use onto the foot stool |
| | |
| | |
| Hot glue just small dabs onto the foot stool until you are sure you have the designs either “Klimt Choir of the angels_lge_03” or “Klimt Choir of the Angels_sm_01”, in the centre of the border. |
| | |
| | |
| The borders and Klimt Choir of Angels properly glued to the foot stool |
| | |
| | |
| This makes a lovely foot stool to display your work |
| | |
| | |
| | |
| Instructions for Klimt Composition Lamp Shade 
|
| | |
| | |
| | Stitch out Klimt Choir of the Angels in the colours that would best suite your surroundings; this is a very simple and easy way of showing your designs |
| | |
| | |
| | |
| | |
| Instructions for Klimt Composition Cushion 
|
| | |
| Stitch out “Klimt Water_10” I used the same thread colouring as in the lace so the whole cushion would blend beautifully |
| | |
| | |
| Make up the cushion, once finished I used this beautiful antique lace I had purchased early in the year to surround the cushion |
| | |
| | |
 | Hand stitch the lace to your cushion |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
| | |
